76
Access
Locking the vehicle with
perimeter monitoring only
Deactivate the interior volumetric and tilt
monitoring to avoid unwanted triggering of the
alarm in certain cases, such as:
- an animal left in the vehicle,
- a window left partly open,
- washing your vehicle.
Deactivation of the interior
volumetric and tilt monitoring
Raise and hold the wiper control stalk in
the " MIST " position for about three seconds to
activate them again, the audible signal
sounds twice .
) Switch off the ignition and remove the
key from the ignition switch (OFF mode if
your vehicle has the "Keyless Entry and
Starting" system).
) Raise and hold the wiper control stalk in
the "MIST" position for about 3 seconds.
) The audible signal sounds once and the
interior volumetric and tilt monitoring are
deactivated.
To Next Page
Loading...
