CITROEN C5 2000 - Page 87

ENGINE
84
Setting the valve timing (continued).
Tighten :
- The screw of the roller (19) to 2.5 ± 0.2 m.daN.
- The screws (21) to 2. ± 0.2 m.daN.
- Remove the tool [1].
- Refit the tool [1].
- Tension value should be :
54 ± 3 SEEM units.
IMPERATIVE : If value is incorrect, restart the operation
- Remove tools [1], [3] and [5].
- Rotate the crankshaft 2 times (normal direction of rotation).
- Fit the tool [3].
WARNING : Should it be impossible to peg the camshaft, check
that the offset between the camshaft pinion hole and the pegging
hole is not more than 1 mm.
In the case of an incorrect value, recommence the operation.
- Remove the tool [3].
- Complete the refitting of components.
CHECKING AND SETTING THE VALVE TIMING
Engines : RHY - RHZ
B1EP156D