SAFETY
Rear central seat belt
Using the seat belt
(C4 Picasso)
Open the cover A .
Remove the belt tongues from
their housing.
Bring the belt tongues up to the
relay ring B .
Insert the attachment, then pass
the tongues through the ring.
Close the cover A . Make sure
that the belt is correctly posi-
tioned in the recess in the cover
provided for this purpose.
Stowing the belt tongues
(C4 Picasso)
Operate in reverse order to stow
the belt tongues.
You may opt to leave the seat belt in
the relay ring even if not using it.
Routing of the seat belt
(C4 Picasso and
C4 Grand Picasso)
Insert the tongue C into the buckle
on the right, then insert the sec-
ond tongue D into the buckle on
the left.
Unfastening the seat belt
(C4 Picasso and
Grand C4 Picasso)
Release the buckle C , then the
buckle D and guide the seat belt
to its stowing position.
Before use
For safety reasons, it is essential
that the seat belt passes through
the relay ring.
To avoid damaging or jamming the
seat belts, stow them carefully on
the sides of the seat backrests.
To Next Page
Loading...
