The electric parking brake operates
as follows:
- Automatic application/release
Application is automatic when the
engine stops, release is automatic
on use of the accelerator.
- Manual application/release
Manual application/release of
the parking brake is possible by
pulling control A while pressing
the brake pedal.
Manual application
With the vehicle stationary, to apply
the parking brake whether the engine
is running or off, pull on control A .
Manual release
With the ignition on or the engine
running, to release the parking
brake, press on the brake pedal, or
the accelerator, pull then release
control A .
-
the extinction of the warn-
ing lamp P on control A and
on the instrument panel,
- the display of a message "hand-
brake off" on the multifunction
screen.
If you pull control A without pressing
the brake pedal, the parking brake
will not be released and the "Foot on
brake" warning lamp will light up on
the instrument panel.
The application of the parking brake
is confi rmed by:
- the lighting of the warning
lamp P on control A and
on the instrument panel,
- the display of a message "hand-
brake on" on the multifunction
screen.
When the driver’s door is
opened with the engine run-
ning, a beep is heard and a
message displayed if the parking
brake has not been applied.
Before getting out of the vehicle,
check that the warning lamp P is lit
permanently on the instrument panel.
The full application of the parking
brake is confi rmed by:
To Next Page
Loading...
