Procedure for replacing a faulty bulb
with a new bulb without the use of
tools.
In some climatic conditions (e.g.
low temperature or humidity), the
presence of misting on the internal
surface of the glass of the head-
lamps and rear lamps is normal;
it disappears after the lamps have
been on for a few minutes.
The headlamps are fi tted
with polycarbonate glass
with a protective coating:
do not clean them using a
dry or abrasive cloth, nor
with a detergent or solvent
product,
use a sponge and soapy water,
when using a high pressure
washer on persistent marks, do
not direct at the lamps or their
outlines for too long, so as not
to damage their coating and
their seals.
Do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a halogen bulb should
only be done after the headlamp
has been switched off for a few
minutes (risk of serious burns).
It is imperative to use only anti-
ultraviolet (UV) type bulbs in order
not to damage the headlamp.
Dipped beam headlamps
Remove the rubber cover.
Rotate the bulb-holder a quarter
turn anti-clockwise and remove it
from its housing.
Replace the faulty bulb.
Reposition the bulb-holder by
pushing it in, tightening it by a
quarter turn clockwise.
Refi t the rubber cover.
Front lamps
1. Dipped beams (H7-55 W)
2. Main beams (H1-55 W)
3. Sidelamps (H6 W-6 W)
4. Direction indicators
(H21-21 W)
Model with halogen headlamps
To Next Page
Loading...
