To install:
- position one end of the load space cover
roller in its notch,
- compress the opposite end of the roller
and put it in place,
- release it so that it engages,
- unroll the load space cover to the pillars,
- fix the two hooks on the pillars.
Use the stowing rings on the rear floor to fix
the net, your loads or luggage.
For safety reasons, on sharp braking, it is
recommended that heavy objects are placed
as far forward as possible.
To remove:
- pull the load space cover towards you to
disengage it from its fixings,
- reinsert the load space cover in its roller,
- compress it and remove it from its
support.
You are advised to immobilise the load
by securing it firmly using the stowing
rings on the floor.
To Next Page
Loading...
