8
AX4000G Series
How to order
AX4000G
Actuator
Model no.
Size
(max. torque)
A
Driver type
B
Cable change
Note 2
D
Mounting base
Note 3, Note 4,
Note 6
C
Driver power
voltage
Note 1
F
Dowel hole
Note 4, Note 5
H
Body surface treatment
Note 3
I
Brake
Note 6
E
How to order
AX4
A
Size (max. torque)
Symbol
Descriptions
009
022
045
075
9 N·m
22 N·m
45 N·m
75 N·m
B
Driver type
GS GS type driver
C
Mounting base
(cannot be used with dowel holes P2 and P3)
Blank
B
BS
Standard (without mounting base)
With blackening mounting base
Electroless nickel plating, surface treatment mounting base
Use with body surface treatment S.
D
Cable change
Blank
D**
DM**
Standard (cable length 4 m)
Cable length change
Flexible cable length change
H
Dowel hole
Blank
P1
P2
P3
Standard (without dowel hole)
1 on top
1 on bottom (2 on the bottom for AX4009G)
1 each on both top and bottom
(1 on the top, 2 on the bottom for AX4009G)
I
Body surface treatment
Blank
S
Rotational section: electroless nickel
plating treatment, fixing section: nitriding
Standard (rotational section - blackening,
fixing section casting surface plane - paint)
E
Brake
Blank
EB
Standard (without electromagnetic brake)
With negative actuation type electromagnetic brake
022 P1DM08 J1EBBSGS S
CE marking
Note 6
G
K
Note on model no. selection
Note 1: Select the driver according to the table below.
Driver - power voltage table
* Contact CKD when ordering parts individually for maintenance.
Model
Driver
type
GS type driver
3 phases
200 to 230 VAC
Single phase
100 to 115 VAC
AX4009G
AX4022G
AX4045G
AX4075G
Blank
Blank
Blank
Blank
J1
J1
J1
F
Driver power voltage
Refer to the driver - power voltage table on the left.
**cable length
02
Blank
06
08
10
15
20
2 m
4 m
6 m
8 m
10 m
15 m
20 m
Flexible cable 4 m: DM
Model Model no. of options
G
CE marking
Blank
K
Standard (CE marking not available)
CE marking
AX4009G AX4022G AX4045G AX4075G
Mounting base (-B)
Mounting base (-BS)
Brake (-EB)
CE marking (-K)
X
X
X
X
Option table
[Note]
Use the noise filter for the
motor cable if the cable is
longer than 6 m.
Note 2: Use the optional flexible cable in applications where the cable is bent repeatedly.
Refer to page 9 for the cable dimensions.
Note 3:
Designate body surface treatment and mounting base surface treatment with (C) and (I).
Note 4:
"P2" and "P3" cannot be selected if "B" with blackening mounting base or "BS" electroless
nickel plating surface treatment mounting base is designated for (C) mounting base.
Note 5: Additionally machined sections may not have a treated surface.
Note 6: Refer to the Option Table below and select required options.
To Next Page
Loading...
