28
AX2000
AX2000
Series
How to order
Actuator
Model no.
Size
(max. torque)
A
Driver type
Note 1
B
Mounting base
Note 4
D
Hollow fixed shaft
Note 2
C
Cable change
Note 3
E
Driver power voltage
Note 1
F
CE marking
G
How to order
AX2
A
Size (max. torque)
Symbol
Descriptions
006
012
021
042
6 N·m
12 N·m
21 N·m
42 N·m
B
Driver type
S S type driver
D
Mounting base
(cannot be used with dowel holes P2 and P3)
Blank
B
Standard (without mounting base)
With blackening mounting base
G
CE marking
Blank
K
AX2006 AX2012 AX2021 AX2042
Hallow fixed shaft (-A)
Flexible cable (-DM)
XX
X
X
X
X
X
X
Standard (CE marking not available)
CE marking
C
Hollow fixed shaft
Blank
A
Standard
Hollow fixed shaft extension
(Only AX2021, AX2042 available)
D08021 S BA J1 K
Note on model no. selection
Note 1: Select the driver according to the table below.
Model
Driver - power voltage table
Option table
Driver
type
S type driver
(including CE products)
H type driver
200 to 230 VAC 200 to 230 VAC 100 to 115 VAC
100 VAC
AX2006
AX2012
AX2021
AX2042
Blank
Blank
Blank
Blank
J1
J1
J1
J1
Model Model no. of options
Dowel hole
Note 4, Note 5
H
P1
E
Cable change
Blank
D**
DM**
Standard (cable length 4 m)
Cable length change
Flexible cable length change
H
Dowel hole
Blank
P1
P2
P3
Standard (without dowel hole)
1 on top
1 on bottom
1 each on both top and bottom
F
Driver power voltage
Refer to the driver - power voltage table on the left.
** cable length
Note: The length and type cannot be changed after delivery.
02
Blank
06
08
10
15
20
25
30
2 m
4 m
6 m
8 m
10 m
15 m
20 m
25 m
30 m
Flexible cable 4 m: DM
(Only AX2006,
AX2012 available)
[Note]
Use the noise filter for the
motor cable if the cable is
longer than 6 m.
* S type driver is recommended if the max. torque is 42 N·m or less.
Contact CKD for details on the availability of the H type driver.
Note 2: Refer to the Option Table and select required options.
Note 3: Use the optional flexible cable in applications where the cable is bent repeatedly.
(Only AX2006, AX2012 available)
Refer to page 57 for dimensions of the cable.
Note 4: "P2" and "P3" cannot be selected if "B" with a blackening base is designated for (D)
mounting base.
Note 5: Additionally machined sections may not have a treated surface.
1 on top (-P1)
1 on bottom (-P2)
1 each on both top and bottom (-P3)
Dowel hole
To Next Page
Loading...
