Need help?Do you have a question about the Clack Valves WS1 and is the answer not in the manual?
Details the two stages of the backwash process: Backwash and Fast Rinse.
Requirements for a firm, level area and drain/gully for backwash water flow.
Lists the specifications for raw water quality to be fed to the filter.
Discusses acceptable pipework materials and the need for proper alignment and support.
Details the process for programming regeneration cycles, including backwash and rinse times.
Guides users on programming settings like hardness levels and regeneration frequency.
Outlines steps to fill the filter, check for leaks, and initiate manual backwash and regen cycles.
Lists checks for no water flow, including pressure, valves, and potential media fouling.
Provides troubleshooting steps for poor water quality, such as checking bypass and backwashing.
General| Valve Size | Up to 1" |
|---|---|
| Backwash | Yes |
| Meter | Optional |
| Bypass | Optional |
| Inlet/Outlet | 1" NPT |
| Drain Line | 1/2" |
| Brine Line | 3/8" |
| Riser Tube | 1.05" |
| Materials | Noryl |
To Next Page
