120
Delete coupling
To call up the menu BT CONFIG, keep the
button pressed until "BLUETOOTH" is shown on the
display. Subsequently, press the button
.
Press the function button and, where necessary, use the rotary knob to select the coupling to
be deleted.
Confirm deletion by pressing the function button .
If this Bluetooth device should be used again, it has to be re-coupled ( Page 119 "Coupling Bluetooth
device").
Bluetooth menu
In the Bluetooth menu BT CONFIG, you are able activate different functions and carry out settings.
To call up the menu BT CONFIG, keep the
button pressed until "BLUETOOTH" is shown on the
display. Subsequently, press the button
.
If no other selections are made then the menu is automatically closed after a few seconds.
Phone book transfer (APB)
The phone book automatically transferred from the mobile telephone to the radio during coupling can be
manually updated.
In the menu BT CONFIG, press the function button .
If necessary, access to the phone book data must still be authorised on the telephone.
Data transfer starts and is indicated by "PB DOWN" on the display of the radio. This may take some time
depending on the size of the data saved. At the end of the data transfer, "PBA SAVE" is shown on the
display.
It is possible to save up to 500 entries in the phone book. If the phone book is considerably large, the
radio can respond with a delay whilst saving/sorting.
Bluetooth volume (BT VOL)
When switching on, the maximum volume for playback via Bluetooth audio can be set and saved.
Hereby, adaption to different Bluetooth devices can be carried out.
In the menu BT CONFIG, press the function button .
Set the desired playback volume using the rotary knob Fig. 1 (BT VOL 06...31 or BT VOL MAX).
During playback of music tracks via Bluetooth audio, the volume can be set as usual
using the rotary
knob
Fig. 1 .
Call tone volume (RING VOL)
During an incoming call, the current audio playback is interrupted and the call tone is played back via the
vehicle speakers. The playback volume of the call tone can be set.
In the menu BT CONFIG, press the function button .
Set the desired call tone volume using the rotary knob Fig. 1 (RING VOL 03...09 or
RING VOL MAX).
The call tone volume can be adjusted during an incoming call using the
rotary knob
Fig. 1 you are
able to change the volume during the call. These settings are saved for the following phone calls.
To Next Page
Loading...
