Clarion DRB3475 - Storing the DCP in the DCP Case; Removing the DCP; Attaching the DCP

3. DCP (Detachable Control Panel)
The control panel can be detached to prevent
theft. After detaching the control panel, store it in
the DCP case to prevent scratches.
We recommend taking the DCP with you when
leaving the car.
Removing the DCP
1. Turn the power off.
2. Press the DCP release button |T|-
3 Pull the left side of the DCP toward you to
remove it.
Attaching the DCP
1. Insert the right side of the DCP into the
source unit opening first.
2, Press on the left side of the DCP face to snap
it into place
_ A CAUTION _
Do not insert the left side of the DCP In place
first and try to force the right side Into place.
Attempting to do so will damage the DCP or
the locking mechanism.
Storing the DCP in the DCP Case
1. Hold the DCP in the orientation shown in the
figure below.
2. Insert it into the DCP case.
3. Close and snap the case cover shut.
_ A CAUTION _
• The DCP can easily be damaged by shocks.
After removing it, be careful not to drop it
or subject it to strong shocks.
• The connector connecting the source unit
and the DCP is an extremely important part.
Be careful not to damage It by pressing on
it with fingernails, screwdrivers, etc.
Note:
• If the DCP is dirty, wipe off the dirt with a soft, dry
doth only.