Clarion DUZ385SAT - Sound Adjustment

Basic Operations
English
13 DUZ385SAT
Sound Adjustment
You can adjust a sound effect or tone quality to
your preference.
● Setting the Z-Enhancer Plus
This unit is provided with 4 types of sound tone
effects stored in memory.
Select the one you prefer.
∗ The factory default setting is “OFF”.
2-1. Select “Z-EHCR”.
3-1. Each time you press the [w] or [z] button,
the tone effect changes in the following
order:
“Z+FLAT” ↔ “CUSTOM” ↔ “EXCITE” ↔
“IMPACT” ↔ “B-BOOST” ↔ “OFF”
Z+FLAT :user Z+FLAT
CUSTOM : user custom
EXCITE : bass and treble emphasized
mid emphasized
IMPACT : bass and treble emphasized
B-BOOST : bass emphasized
OFF : no sound effect
When “Z+FLAT” is set:
3-2. Press and hold the [ ] button for
1 second or longer, bass/treble
characteristics become flat and switch to
the “CUSTOM” mode.
When “CUSTOM” is set:
3-2. Press the [ ] button to enter the “BASS/
TREBLE” adjust mode.
When “EXCITE/IMPACT/B-BOOST” is set:
3-2. Press the [ ] button.
3-3. Press the [w] or [z] button to adjust the
setting in the range of
–3 to +3.
∗ The factory default setting is “0”.
3-4. Press the [ ] button to return to the
previous mode.
● Adjusting the bass/treble
This adjustment can be performed only when
the Z-Enhancer Plus is set to “CUSTOM”.
3-2. Press the [ ] button.
3-3. Press the [x] or [v] button to select as
following order.
BASS G ↔ BASS F ↔ BASS Q ↔
TREBLE G ↔ TREBLE F
The factory default setting is “BASS G”.
3-4. Press the
[] button.
3-5. Press the [w] or [z] button to select the
setting.
BASS G: The factory default setting is “0”.
(Adjustment range: +7 to
–7)
BASS F : The factory default setting is
“60”.
(Adjustment range: 60/80/100/
200)
BASS Q: The factory default setting is “1”.
(Adjustment range: 1/1.25/1.5/2)
TREB G: The factory default setting is “0”.
(Adjustment range: +7 to –7)
TREB F : The factory default setting is
“10K”.
(Adjustment range: 10K/12.5K/
15K/17.5K)
3-6. Press the [ ] button to return to the
previous mode.
To change sound setting
1. Press the [ ] button to switch to the
sound adjustment selection display.
∗ The factory default sound setting is “Z-
EHCR”.
2. Then press the [x] or [v] button to
select the sound adjustment mode.
Each time you press the [x] or [v]
button, the sound adjustment mode
changes as following order:
“Z-EHCR” ↔ “BALANCE” ↔ “FADER”
∗ In the case of display blinking “ENT”, you
can press the [ ] button to adjust the
setting value.
3. Press the [w] or [z] button to adjust the
selected audio mode.
4. After completing settings, press the [ ]
button to return to the previous mode.
DUZ385SAT_EN.book Page 13 Friday, November 23, 2007 7:49 PM