Clarion QX-3870N-A - Page 22

- 22 -
QX-3870N-A
* Handle according to the product hand manual.
1
The CF PWB screws should not be raised.
A1
A
ffixing position
* Reuse of the copper tape is prohibited.
2
(Fig. 2)
(Fig. 1)
Assembly 9
QX-3870N-A
(NAU-3225KCA-C)
㪈㪇
Work proceduresWork processing drawing
[Product hand manual]
Part No.
Important control items
Qty
MUZ2441
No.
There should be no raised screws or missing parts.
(Refer to Fig. 2.)
Left/Right directions : Attach so that the ڏ and ڎ
parts are almost equal.
Do not oblique excessively.
Check that the half pierces are in the holes and
attach copper foil tape. (Refer to Fig. 1.)
A
fter checking the screws on the front surface of the main unit
assy, attach copper foil tape (A) to the front surface.
Upper/Lower directions : Attach it aligned to th
e
bent portions of the front cover.
OK
NG
Half pierce
There should be no raising of the screw.
A
䃨
䃩
NG
* Do not hold the mechanism frame.
OK