Clarity D703HS - Deregistering Your Handset(s); Deregister All Handsets; Re-registering Handsets

8 9
• Then press # on handset
3. Press and hold FIND on the telephone base for about four
seconds.
4. Press # (pound key) on the handset. The screen shows
Registering...Please wait.
When the handset is registered successfully, HANDSET
registered and then HANDSET X appears on the screen, with X
being the handset number (1-5).
If the registration is not successful, the handset screen shows
Registration failed. Please start again from step 1 above.
Note: You cannot register a handset if any other system handset is in
use. To register an expansion handset, follow from the step 3 as above.
HOW TO REGISTER YOUR HANDSET
Deregister all handsets
You can deregister handsets. You may need to deregister your handsets
if:
You have ve registered handsets and need to replace a handset.
-OR-
You wish to change the designated handset number of your
registered handsets.
You must rst deregister ALL the handsets, and then register each
handset you wish to use again, one at a time.
1. Press and hold FIND on the telephone base for about 24
seconds; release FIND.
2. Immediately press FIND again.
3. When complete, the handset screen alternately shows
• Press HS LOC on base 4 sec
and
• Then press # on handset.
4. To register the handset(s) to the telephone base again, follow
the registration instructions in section Register a handset.
NOTE: There are no visual or audible alerts to indicate
the base is under deregistration mode.
HOW TO DEREGISTER YOUR HANDSET(S)