Clark C500 100 - Stopping and Parking

Engine Starting Procedure
Gasoline and L.P. Gas
1. Be sure that forward-reverse transmission con-
trol lever is in neutral and parking brake is
applied.
2. On L.P. Gas units, open the shut-off valve
slowly. If opened too quickly, an automatic
safety check valve will close. It will then be
necessary to close hand valve for several
minutes and slowly open again.
The hand valve opens by turning counter-
clockwise.
KEY SWITCH 13226M
3. Pull out on choke control.
4. Turn ignition switch key to "start" position
to engage starter. Release to "run" position
when engine starts.
CAUTION: If engine does not start on first
attempt, do not restart until engine comes to
a complete stop (about 5 seconds).
Page 36
L.P. GAS
SHUT-OFF VALVE
1324SM
Code: OI-335 Oct. 73