Clark C500 100 - Adjustments and Hood Operation

ENGINE STARTING PROCEDURE
DIESEL
PIERCING
SHAFT
CAP'
BODV
7. An optional cold weather starting device is available for the G.M.
Diesel engine. Follow this procedure:
— Unscrew cap from body and drop in starting aid capsule.
— With piercing shaft pulled out, screw cap onto body snugly.
— Push piercing shaft all the way in.
— Fully depress accelerator pedal. Engage the starter.
— While cranking the engine, pull pump plunge/ out and then push
in slowly until engine starts. After engine starts, continue pushing
plunger very slowly until it seats. See sample. — Remove capsule
and reassemble with piercing shaft "down".
G.M. DIESEL
STARTING AID
13296M
8. With engine running, re-check all instruments and gauges to make
sure they are operating properly. Especially note the engine oil
pressure indicator. If pressure does not build up immediately, shut
off engine and report condition to designated authority.
NOTE: Run engine for several minutes before operating to allow
adequate lubrication to reach all moving parts . . . especially in cold
operating conditions.
STARTING AID PUMP
13297M
Code: OI-335 Oct. 73
Page 39