Clark GCS 20 - Page 105

Planned Maintenance and Lubrication
Engine Coolant Check
On standard trucks the engine coolant
level is checked by removing the
radiator cap. Remove the cap only
when the engine is cold. Turn the cap
slowly to release any pressure that may
be in the radiator. Then push the cap
fully down and turn to release and
remove the cap.
A WARNING
STEAM
DO NOT REMOVE THE RADIATOR
CAP UHEN THE RADIATOR IS
HOT. STEAH FROM THE RADIATOR
UILL CAUSE SEVERE BURNS.
On custom and industrial option
package trucks, inspect the coolant
level in the overflow bottle only. Do not
remove the cap.
The coolant level should be at the
"Cold Level" line on the coolant
recovery bottle.
NOTICE: Your lift truck cooling system
is filled with a factory-installed solu-
tion of 50% permanent-type anti-freeze
and 50% water, containing rust and
corrosion inhibitors. You should leave
it in the truck year around.
Battery — Water-Fill Type
Check the battery to be sure the cells
are all filled. Inspect for cracks. If the
terminals are corroded, clean and pro-
tect them with Battery Saver.
8.7