To Next PageTo Next Page
Need help?Do you have a question about the Clark GCS 30 and is the answer not in the manual?
Perform a visual inspection of the truck and its components daily.
Check safety equipment like overhead guard, load backrest extension, horn, etc.
Check tire pressure and condition for wear and damage.
Do not operate a truck with a maintenance problem; tag it "Out of Service".
General safety rules illustrated with icons: no drugs/alcohol, watch pedestrians.
Always buckle up seat belts to reduce injuries during operation.
Keep hands, feet, and legs out of the upright; never use upright as a ladder.
Stay with the truck in a tip-over; brace feet and grip the wheel.
Empty trucks can tip easier than loaded ones due to rear-end weight.
Turning too sharp with a raised load can cause tipping even at slow speeds.
Never carry loose or uneven material; spread forks, stack and band loads.
Slack chains can cause hang-up; raise upright before moving.
Step-by-step instructions for starting the truck's engine.
Steps to perform before operating the truck, including daily inspection.
Detailed procedure for safely jump-starting a lift truck with a dead battery.
Procedures for safely towing a disabled lift truck.
General| Model | GCS30 |
|---|---|
| Load Capacity | 3000 kg |
| Mast Type | 2-Stage / 3-Stage |
| Fork Length | 1070 mm |
| Lift Height | 3, 000 - 6, 000 mm |
| Power Type | Electric |
| Rated Load | 3000 kg |
