Clark GCS 30 - High loads

General Safety Rules
Pinch points
Keep hands, feet
and legs out of the
upright.
Don't use the
upright for a ladder.
Never try to repair the
upright, carriage, chain or
attachment yourself...
always get
a trained
mechanic.
2.12
Planned Maintenance and Lubrication
Hydraulic Fluid Level Check
Check the hydraulic sump tank oil level
with:
1. Truck on a level surface.
2. Upright in a vertical position.
3. Fork carriage fully down.
4. Oil at operating temperature.
Pull the dipstick out, wipe it with a
clean wiper, and push it back into the
dipstick tube. Pull the dipstick out
again and check the oil level.
The hydraulic sump tank oil level
should be up to the "F" (full) mark on
the dipstick.
Approximately [3,8 L] 1.0 gal. of
hydraulic oil is required to fill the
hydraulic tank from the "L" (low) mark
to the "F" (full) mark. Do not overfill.
Hydraulic Sump Tank Fluid &
Filter Change
It is recommended to:
• Drain and replace the hydraulic
fluid every 2000 operating hours.
• Replace the hydraulic oil filter at
every oil change.
• Replace the hydraulic sump tank
breather/fill cap every 1000 operating
hours.
IMPORTANT
Use recommended fluid only
Use genuine Clark parts
84M397
24917
84M398
8.9