Clark GCS 20 - Page 20

General Safety Rules
Stay in the confines of the truck
Keep under the
overhead guard
Keep hands on the
wheel.
Keep arms and legs
inside.
O K
Planned Maintenance and Lubrication
HR500 Transaxle
HR500 transaxle has two openings in
drive axle section.
1. Fill/oil level dipstick plug.
2. Drain plug, in lower front surface of
axle center housing.
In addition, HR500 transaxle has a
transmission housing drain plug (3), and
a transmission oil strainer screen
access plug (4) located similarly to
HR600 transaxle.
Transaxle Fluid
Replacement/Refill
HR500 transaxle
After drive axle and transmission
housing has drained completely,
1. Install drain plug in drive axle.
2. Install drain plug in transmission
housing.
3. Remove inspection/filler plug in from
center surface of drive axle housing.
4. Fill transaxle to bottom edge of fill/oil
level plug opening with recommend-
ed fluid noted below. Please refer to
previous instruction on "Transaxle
Fluid Level Check".
5. Install fill/level plug.
6. Remove drain pan. Remove
blocking from under upright (if
used). Lower carriage and forks to
floor.
IMPORTANT
HR500 use only API Class CC.SC, SE,
SF Motor Oil
SAE30@32°F-110°F
SAE10@32°F-(-30°F)
DO NOT SUBSTITUTE.
IMPORTANT
TA18 use only AMOCO 1000 or
TEXACO 1893 TDH CLARK # 2776236
DO NOT SUBSTITUTE.
Fig. 24992
Fig. 24994
2.6