Clarke C18H - Parts Information; Spare Parts; Engine Maintenance Parts List; Owner Assistance

46
Listing of Diagnostic Trouble Codes
105 16 Manifold Air Temperature Input
Voltage High
110 00 Engine Coolant Temperature
Extremely High
110 03 Engine Coolant Temperature Input
Voltage High
110 04 Engine Coolant Temperature Input
Voltage Low
110 16 Engine Coolant Temperature
Moderately High
111
01
Engine Cool
ant Level Low
158
17
ECM Power Down Error
174
03
Fuel Temperature Input Voltage High
174
04
Fuel Temperature Input Voltage Low
611
03
Injector
Shorted to Power Source
611
04
Injector Wiring Shorted to Ground
620
03
Sensor Supply Voltage High
620
04
Sensor Supply Voltage Low
627
01
Injector Supply Voltage Problem
629
12/13
ECM Error
636
02
Cam Position Input Noise
636
08
Cam Position Input Missing
636
10
Cam Position Input Pattern Error
637
02
Cam Position Input Noise
637
08
Cam Position Input
Missing
637 07 Crank Position/Cam Position Out of
Sync
637
10
Crank Position Input Pattern Error
651
05
Cylinder #1 EUI Circuit Open
651
06
Cylinder #1 EUI Circuit Shorted
652
05
Cylinder #2 EUI Circuit Open
652
06
Cylinder #2 EUI Circuit Shorted
65
3
06
Cylinder #3 EUI Circuit Open
653
05
Cylinder #3 EUI Circuit Shorted
654
06
Cylinder #4 EUI Circuit Open
654
05
Cylinder #4 EUI Circuit Shorted
655
06
Cylinder #5 EUI Circuit Open
655
05
Cylinder #5 EUI Circuit Shorted
656
05
Cylinder #6 EUI Circ
uit Open
656
06
Cylinder #6 EUI Circuit Shorted
970 02 Auxiliary Engine Shutdown Switch
Signal Invalid
970 31 Auxiliary Engine Shutdown Switch
Active
971
31
External Fuel De
-
Rate
Switch Active
1109
31
Engine Shutdown Warning
1110
31
Engine Shutdown
1569
31
Fuel De
-
rate
2000
13
Security Violation
NOTE: The PowerView diagnostic gauge can have
communication problems that result in Error Codes
being shown on its LCD display window. The
following Error Codes all indicate that there is a
Diagnostic Gauge communication error with the
ECM. Contact your servicing dealer for help in
correcting these codes:
EE – Error XXXXX – EP
No Data
ACP – Err XXXXX - BO
No Addr No Data
ACP – Err XXXXX - BR
BUS – EP No Data
NOTE: Refer to wiring diagnostic earlier in this
section as a guide to connections and wires.
6.0 PARTS INFORMATION
6.1 SPARE PARTS
To ensure best operation and efficiency of all engine
components, always use genuine Clarke spare parts.
Orders should specify:
 Engine Model Number - See Engine General
 Engine Serial Number - Specification
 Part Number(s) Refer to Engine Maintenance
Parts List section 6.2 or Parts Illustration (see
Page 5).
Contact numbers for spare parts:
• www.clarkefire.com
• Phone USA: (513) 771-2200 Ext. 427 (calling
within USA)
• Phone UK: (44) 1236 429946 (calling outside USA)
• Fax USA: (513) 771-5375 (calling within USA)
• Fax UK: (44) 1236 427274 (calling outside USA)
• E-Mail USA: parts@clarkefire.com
• E-Mail UK: dmurray@clarkefire.com
6.2 ENGINE MAINTENANCE PARTS LIST
Refer to Appendix “A” at the end of this manual.
7.0 OWNER ASSISTANCE
Consult Clarke Service Dealer or Factory. Service
Dealers can be located by going to our website:
www.clarkefire.com.