Clarke CSB20B - User Manual

Other manuals for Clarke CSB20B

Operating & Maintenance Instructions6 pages

Questions and Answers

L
Laura StoneAug 3, 2025
Why is there excessive dust in my Clarke CSB20B cabinet?
- J
  Joy GarciaAug 3, 2025
  If there is excessive dust in the Clarke Tools cabinet, possible causes include: * Not using a dust extraction device. Install a dust extraction device. * Blocked air vent or overflow. Clean the rear vent and keep it away from any wall. * Worn abrasive media. Replace the abrasive media. * Too much abrasive media. Remove the excessive media. * Loose airline or connections. Tighten the fittings and ensure the airline is secure.
V
Vincent MaldonadoAug 9, 2025
What to do if excessive media is blown out of my Clarke CSB20B?
- W
  wrightkatieAug 9, 2025
  If excessive media is blown into the surrounding atmosphere when no vacuum extract is being used with your Clarke Tools, it may be due to: * The lid not being secure. Secure the lid with the swivel clips, adjusting them if necessary. * A missing air vent filter. Replace the filter or temporarily blank off the hole in the rear panel with masking tape.
B
Bruce HallAug 14, 2025
Why is the blasting action uneven in my Clarke CSB20B Tools?
- J
  Juan TaylorAug 14, 2025
  Uneven blasting action in your Clarke Tools may occur because: * There is too much abrasive media in the cabinet. Remove the excessive media. * The abrasive is damp. Renew the abrasive or dry it thoroughly before use. * There is moisture inside the cabinet. Check the airline to ensure it is free from moisture.
K
Kathryn AllenAug 20, 2025
How to improve the blast speed of my Clarke CSB20B?
- S
  Scott YangAug 21, 2025
  If you experience inadequate speed or inefficient blasting with your Clarke Tools, consider these potential causes: * Worn abrasive media. Replace the abrasive media. * Pressure too low. Increase the inlet pressure and ensure the control valve is fully open.
K
kevin32Aug 27, 2025
What to do if there is static electricity with my Clarke CSB20B?
- W
  wmitchellAug 27, 2025
  If static electricity is present when using your Clarke Tools, it could be due to dry weather conditions. Leave the item to be cleaned on the grid.