3
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
SAFETY PRECAUTIONS
1. DO NOT attempt to modify or alter the controller in any way.
2. Observe all electrical precautions. DO NOT allow the EPC800 to be
submerged. Ensure it is protected from the elements at all times.
3. Read and comply with all precautions specified in your pump manual.
CONNECTING THE PUMP TO THE EPC800
The EPC800 is fitted with two cables,
1. One is fitted with a standard 13 amp plug.
• When connected to the mains supply, this cable carries the supply
to both the EPC800 and the pump.
2. The other cable should be fitted with a trailing socket (not supplied).
3. Insert the plug from the pump into the trailing socket.
IMPORTANT: If the EPC800 is to be connected to an outdoor electrical
supply, make sure that both the plug and the socket are of a BS approved
waterproof design and are protected from the elements.
To Next Page
Loading...