26
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Collet Set (MT3)
Part Number: 7610864
Set of 7 Collets for use with HSS End
Mills:
Insert the appropriate collet into the
spindle.
Insert the draw bolt provided, into the
spindle from the top and screw onto
the collet a few turns.
Insert the appropriate mill into the
jaws of the collet and tighten the
draw bolt.
Hold the spindle by means of the
tommy bar, inserted in the hole in the
side of the head and into the hole in
the spindle.
To remove the collet, unscrew the
draw bolt a few turns and tap its
head with a mallet to break the seal
between the collet and spindle.
QUICK RELEASE VICE
Part Number: 7610868
Maximum opening:88mm
Effective jaw size:100x33mm
Maximum opening:88mm
Effective jaw size:100x33mm
To Next Page
