11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
5. Hold the generator steady and
pull the starting handle lightly until
you start to feel resistance.
Then pull sharply to start the
en
gine.
NOTE: You may have to do this
more than once.
NOTE: When you first start the generator, the overload indicator may light
up for a few seconds, this is normal. If the overload indicator is still
lit after 5 seconds, stop the engine and contact your Clarke
dealer.
6. Once the engine has warmed up,
move the choke lever to the “run”
po
sition.
• The generator is now ready to
use.
WARNING: ONCE THE GENERATOR HAS STARTED, RELEASE THE STARTING
HANDLE SLOWLY TO AVOID INJURY/DAMAGE AS IT RECOILS.
To Next Page
Loading...
Need help?
General
