What to do if Clarke Inverter fails to generate electricity?
If your Clarke Inverter isn't generating electricity, first ensure the device you're trying to power is functioning correctly. If the overload indicator is illuminated, disconnect the appliance immediately and avoid connecting any appliance exceeding 2.2 KVA. For DC supply issues, check if the DC Overload protector has activated and press the reset button if needed.
Why Clarke Power IG2200 Inverter generator fails to start?
If your Clarke Inverter fails to start, make sure the engine switch is in the ‘on’ position. Check the oil level and add more if needed. Also, ensure there's enough fuel in the generator. Finally, inspect the spark plug and replace it if it's not working correctly.
Ensure the generator is used in a well-ventilated area, away from people and flammable materials.
Place the generator on a solid, flat surface at least 1m from buildings to prevent overheating.
Always switch off the engine when refuelling and avoid smoking near the generator.
Avoid wet conditions, wet hands, and never use water to clean the generator. Ensure proper grounding.
Do not exceed load rating, disconnect for maintenance, and never connect to mains supply.
Connect the generator to an earth point for safety before operation.
Inspect and clean the air filter as per instructions to ensure optimal performance.
Verify the engine oil level is within the recommended range before starting the generator.
Ensure sufficient fuel is present in the tank; do not overfill.
Step-by-step guide on how to safely start the generator, including choke and primer bulb usage.
Instructions for connecting AC and DC appliances safely to the generator.
Understand how the economy switch affects engine speed, fuel consumption, and noise.
Learn the meaning of pilot, overload, and low oil indicators for safe operation.
Proper procedure for safely stopping the generator after use.
Detailed steps for draining and refilling engine oil every 20 hours of use.
Guide on cleaning or replacing the air filter every 50 hours of use.
Instructions for checking, cleaning, and gap adjustment of the spark plug.
Procedure for checking and cleaning the fuel tank filter for optimal fuel delivery.
To Next Page
General
