16
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ECONOMY SWITCH
When the economy control switch is
turned on, the engine speed varies
according to the load connected.
This results in decreased fuel
consumption and less noise.
When the economy control switch is
turned off, the engine runs at the
5,000 r/min. regardless of whether
there is a load connected or not.
INDICATOR LIGHTS
PILOT LIGHT
The pilot light (Green) will remain on
during nor
mal operation.
OVERLOAD INDICATOR
The overload indicator (Red) will light
up if there is an overload or a short
circuit in the connected appliance.
If this happens, proceed as follows:
1. Turn off any connected electrical
device
s
and stop the engine.
2. Reduce the total wattage of connected electric devices to within the
rated output of the generator.
3. Check air inlet and around the control unit. If any blockages
are found,
remove them.
4. After checking, restart the engine.
LOW OIL INDICATOR
The oil indicator will light up when the oil level is low. To add oil, follow the
instructions on page 10
CAUTION: THE ECONOMY CONTROL DOES NOT WORK EFFECTIVELY IF
THE ELECTRICAL APPLIANCE REQUIRES ‘BURSTS’ OF POWER.
CAUTION: TURN THE ECONOMY CONTROL FEATURE OFF WHEN
CONNECTING HIGH LOAD APPLIANCES OR WHEN CONNECTING TO THE
DC OUTPUT.
To Next Page
Loading...
Need help?
General
