What to do if my Clarke Power G1200 Portable Generator fails to generate electricity?
If your Clarke Portable Generator fails to generate electricity, first ensure that the device you are trying to power is working correctly. Also, if the AC Circuit Breaker has activated, remove the appliance immediately, wait 2-3 minutes, and then press the AC Circuit Breaker/reset button. Avoid connecting appliances requiring more than 1100W.
Why won't my Clarke Power G1200 start?
Your Clarke Portable Generator may fail to start due to a few reasons. First, check that the engine switch is set to ‘on’. If not, set it accordingly. Also, ensure that there is enough fuel in the generator. Finally, a defective spark plug can prevent starting, so consider changing the spark plug.
General| Maximum Output Wattage | 1200 Watts |
|---|---|
| Engine Type | 4-Stroke OHV |
| Fuel Type | Gasoline |
| Run Time at 50% Load | 8 Hours |
| Noise Level | 68 dB |
| Starting System | Recoil |
| Outlets | 1x 12V DC Outlet |
Warns against using the generator in wet conditions and handling with wet hands.
Explains symbols for general hazards and dangerous voltage.
Covers symbols for flammable materials, hot surfaces, and poisonous fumes.
Alerts users to dangers of connecting to building electrical systems without proper isolation.
Details the requirement to connect the generator to an earth point for safety.
Lists critical warnings about fuel flammability, spillage, and cap tightening.
Step-by-step guide for starting the generator engine, including choke and switch operation.
Highlights precautions for appliance condition, load limits, inductive loads, and sensitive electronics.
Provides safety instructions for connecting and charging batteries, including lead disconnection order.
Strictly prohibits the use of flammable solvents or petrol for cleaning the air filter.
Lists common causes like engine switch or fuel issues and their solutions.
Addresses issues with power output, including circuit breaker activation.
To Next Page
