EasyManuals Logo

Clas Ohlson E0062A User Manual

Clas Ohlson E0062A
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
English
Setting thealarm
The default alarm setting is 06:00.
1. Hold in the[ AL ] until thehour digits flash, then press [ ] or [ ] to adjust thehour.
2. Press [ AL ] to confirm and move to theminutes. The minutes digits will flash,
press [ ] or [ ] to adjust them.
3. Press [ AL ] to save thealarm time setting and return to normal clock mode. If no button is
pressed for 8 seconds, theclock will automatically return to normal clock mode.
4. A single, short press of the[ AL ] button at any time, will activate/deactivate
thealarm. “AL” is shown on thedisplay when thealarm is activated.
Turning off thealarm
The alarm sounds for aduration of 2 minutes and then turns off automatically.
The alarm can be turned off before the2 minutes has elapsed by:
1. Pressing [ SNOOZE/DIMMER ], thealarm will sound again after 5 minutes or
whatever time has been set (refer to theManual time setting section above).
2. Pressing any button except [ SNOOZE/DIMMER ], will turn thealarm off for
24 hours.
Adjusting thebrightness of thedisplay
Short presses of the[ SNOOZE/DIMMER ] button will toggle between thedisplay’s
two brightness levels.
Care and maintenance
Clean thealarm clock using alightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
Troubleshooting guide
The alarm clock loses contact
with theoutdoor sensor and
thedisplay shows (- -).
Take in theoutdoor sensor and remove
thebatteries (this resets thesensor).
Check thebatteries and replace if necessary.
Insert new batteries and connect theunits in
accordance with theinstructions above.
The signal from theoutdoor sensor is
affected by interference from other electrical
devices, furniture or physical structures.
Try moving the sensor to another location.
The alarm clock is functioning
abnormally and/or displaying
strange readings.
Press [ RESET ] (12) on theback of thealarm
clock.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clas Ohlson E0062A and is the answer not in the manual?

Clas Ohlson E0062A Specifications

General IconGeneral
BrandClas Ohlson
ModelE0062A
CategoryAlarm Clock
LanguageEnglish

Related product manuals