-6-
MONO
Firstly, please read through the previous Stereo section for general notes on securing good
connections, and safety tips. If the unit has been previously used in stereo, make sure it is OFF, and
remove all connections, including AC line cable. Remove amplifier top and make sure the
STEREO/MONO toggle lever located on the main PCB circuit board is pointed closest to the
MONO position. Replace top.
The MONO "Input" is the "left channel input", as marked. The unused right channel input is
automatically disconnected. The "Output connections" are marked "MONO" BESIDE the
connectors. (Do not connect to stereo connectors.)
Repeat the above MONO settings and connections on the second 10 to be used for the other
channel.
Please remember that the negative output connection of a bridged amplifier is NOT a
ground. Do not use a "common ground" or switchbox set-up. Do not use with electronic crossovers
which have a common ground.
To Next Page
Loading...
