Need help?Do you have a question about the Classic Accessories QUAD GEAR and is the answer not in the manual?
Enclosure does not protect against noise, exhaust, chemicals, collisions, roll-over, or other accidents.
Open a side door for ventilation to prevent carbon monoxide buildup when UTV is idling.
Operating the UTV with this enclosure installed will restrict your field of vision.
Using this enclosure does not negate the necessity of wearing a helmet.
Do not transport your UTV on an open trailer or truck with the enclosure installed.
Warranty is void if the installed UTV enclosure is transported on an open trailer or truck.
Loosely drape enclosure shell over UTV with 'BACK' label facing rear, attach front straps to frame.
Attach rear straps to vertical supports, wrap roof straps around cage bars, and tighten front straps.
Fit back of enclosure, tighten rear straps, check alignment, and zip driver/passenger doors.
Apply adhesive-backed rip-and-grip tape to UTV roll cage corresponding to enclosure strips.
Doors can be rolled sideways out of the way or unzipped and removed completely.
Clean plastic with water and soft cloth; fabric with brush and water. Air dry.
Ensure enclosure is completely dry before storing for extended periods to prevent mildew.
Enclosure does not protect against noise, exhaust, chemicals, collisions, roll-over, or other accidents.
Open a side door for ventilation to prevent carbon monoxide buildup when UTV is idling.
Operating the UTV with this enclosure installed will restrict your field of vision.
Using this enclosure does not negate the necessity of wearing a helmet.
Do not transport your UTV on an open trailer or truck with the enclosure installed.
Warranty is void if the installed UTV enclosure is transported on an open trailer or truck.
Loosely drape enclosure shell over UTV with 'BACK' label facing rear, attach front straps to frame.
Attach rear straps to vertical supports, wrap roof straps around cage bars, and tighten front straps.
Fit back of enclosure, tighten rear straps, check alignment, and zip driver/passenger doors.
Apply adhesive-backed rip-and-grip tape to UTV roll cage corresponding to enclosure strips.
Doors can be rolled sideways out of the way or unzipped and removed completely.
Clean plastic with water and soft cloth; fabric with brush and water. Air dry.
Ensure enclosure is completely dry before storing for extended periods to prevent mildew.
General| Brand | Classic Accessories |
|---|---|
| Model | QUAD GEAR |
| Category | Automobile Accessories |
| Language | English |
To Next Page
