Classic Accessories Overdrive PolyPro 3 Deluxe - User Manual

WARNING!
Installation is best done with two people
and on most RVs requires working from the
roof of the RV. Never install on a windy day
or when the RV roof is slippery. Please take
care when you are on a ladder or the roof.
CAUTION
Installation and removal is safer and easier
when done by two people. Please consult
your RV owners manual.
Tools Needed:
• Scissors
• Matchesorlighter(optional)
• Screwdriver(usuallyPhillipshead)for 
roof antennas
Installation
1. Cover or tape any sharp edges on your RV
thatcouldwearagainstyourRVcover.Be
sure to lower any roof antennas.
2.OnsmallerRVsyourcovercanbe
installed with ladders but on most RVs it’s
easiesttoinstallyourcoverfromtheroof.
Carefullyclimbupontheroofandhavea
friendhandyouthecoverinitsstoragebag.
AtthefrontofyourRVcarefullyremoveyour
coverfromitsstoragebag.WiththeClassic
logotothefrontofyourRV(Thecover
shouldbepackedsothatthefrontisatthe
outsideoftheroll)unrollthecoverdown
the length of the roof. Drop the front of your
coveroverthefrontofyourRVthencarefully
andslowlymovetowardthebackoryour
RVspreadingoutyourcoverandlettingthe
sides fall down the sides of your RV.
 Climbdowntherearladderandlocatethe
laddercap.(Thecaphelpskeepthetopof
theladderfromstressingthecover).Fitit
overtheladdertopandattachittotherungs
with the hook and loop straps. Now pull the
backendofthecoverdownthebackofyour
RV.
3.Zipallthepanelsclosedonyourcover
thenpulltheelasticizedcornersdownover
both bumpers of your RV.
4. Tieanendofthe
supplied rope onto
one of the D-rings
along the bottom
hem.Putasmall
rockintheprovided
tossbag,closethe
top and tie the free
end of the rope to
thebagD-ring.Toss
the bag and rope
under your RV to
the D-ring on the
oppositeside.Take
the rope off the bag
and,allowingenoughtomakeaknot,cutit
off and tie it to the D-ring. Repeat with the
remaining D-rings.
 Tokeeptheropeendsfromfrayingyou
cancarefullymelttheendswithamatchor
lighter.
5. Adjust the strap length on the white
tensionpanelsacrossthefrontandbackto
fit your RV. Don’t over tighten—the straps
shouldbesnug,notdrumtight.Toattach
thestrapsintotheside-releasebucklesjust
inserttheclipintothebuckle.Toreleasethe
bucklepressthebuttonsonbothsidesand
pulltheclipoutofthebuckle.
Use and Storage
Thesidesofyourcovercanbeunzipped
foraccesstothedoors,engineorstorage
areas.Thepanelscanberolledupand
heldinplacewiththehookandloopstraps
towardthetopofeachpanel.
Ahandystoragebagisprovided.Tofitit
inthebagfoldyourcoverandrollthecover
tightly rather than stuffing it. Never store
awetcoverinthestoragebagorconfined
areaasthecovercanbedamagedby
mildew.
Care
Spotcleanwithwater,amildsoapanda
sponge.Don’tuseabrasivecleanersor
brushes.
70263, 70363, 70463, 70563, 70663, 70763, 70863
ExtraTallModels:77563, 77663, 77763, 77863
Instructions: PolyPro3
™
Deluxe Class A RV Cover
12cR55_12856
do not
pack wet
do not iron
line dry
water
resistant
do not
use soap
CLASSICACCESSORIES,INC.
KENT,WAUSA98032 ©2012
classicaccessories.com

Summary

Tools Needed

Installation Steps

Prepare RV Surface

Cover or tape sharp edges on RV to prevent wear. Lower any roof antennas.

Install Cover from Roof

Install cover from roof, unroll down length, drape front over RV, move to back, attach rear ladder cap with straps.

Secure Cover Corners

Zip all panels closed and pull elasticized corners over RV bumpers.

Secure with Tie-Down Rope

Tie rope to D-ring, toss under RV to opposite D-ring, knot and cut. Repeat for remaining D-rings.

Adjust Tension Straps

Adjust white tension panels for snug fit. Attach straps to side-release buckles.

Use and Storage

Care Instructions

Classic Accessories Overdrive PolyPro 3 Deluxe Specifications