Classique CLFG67SS - Installation and connection

15/EN
1
Stability hook
2
Locking mechanism
3
Safety chain (supplied and mounted to oven)
4
Firmliy fix chain to cooker rear
5
Rear of cooker
6
Kitchen wa
ll
Stability chain to be as short as practicable to
avoid oven tilting forward and diagonal to avoid
oven side tilting.
Cooker stability chain for cookers not designed with
bracket engagement slot.
Room ventilation
All rooms require an openable window, or equvalent,
and some rooms will require a permanent vent as well.
The air for combustion is taken from the room air and
the exhaust gases are emitted directly into the room.
Good room ventilation is essential for safe operation of
your appliance. If there is no window or door available
for room ventilation, an extra ventilation must be
installed.
The appliance may be located in a kitchen,
kitchen/diner or a bed-sitting room, but not in a room
containing a bath or shower. The appliance must not
be installed in a bed-sitting room of less than 20m
3
.
Do not install this appliance in a room below ground
level unless it is open to ground level on at least one
side.
Room size
Room sizeRoom size
Room size
Ventilation opening
Ventilation openingVentilation opening
Ventilation opening
smaller than 5 m
3
min. 100 cm
2
5 m
3
to 10 m
3
min. 50 cm
2
greater than 10 m
3
not required
In the cellar or
basement
min. 65 cm
2
Installation and connection
Product can only be installed and connected in
accordance with the statutory installation rules.
Do not install the product next to refrigerators
or freezers. The heat emitted by the product
will increase the energy consumption of
cooling appliances.
• Carry the product with at least two persons.
• Product must be placed directly on the floor. It
must not be placed onto a base or a pedestal.
Do not use the door and/or handle to carry or
move the product. The door, handle or hinges
get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated in
the "Technical specifications" table. Have the
grounding installation made by a qualified electrician
while using the product with or without a transformer.
Our company shall not be liable for any damages that
will arise due to using the product without a grounding
installation in accordance with the local regulations.
DANGER:
The product must be connected to the mains
supply only by an authorised and qualified
person. The product's warranty period starts
only after correct installation.
Manufacturer shall not be held responsible for
damages arising from procedures carried out
by unauthorised persons.
DANGER:
The power cable must not be clamped, bent or
trapped or come into contact with hot parts of
the product.
A damaged power cable must be replaced by
a qualified electrician. Otherwise, there is risk
of electric shock, short circuit or fire!
Where to find your model number and serial
Where to find your model number and serial Where to find your model number and serial
Where to find your model number and serial
number
numbernumber
number
The mains supply data must correspond to the data
specified on the type label of the product. The rating
plate is either seen when the door or the lower cover is
opened or it is located at the rear wall of the unit
depending on the unit type.
Power cable of your product must comply with the
values in "Technical specifications" table.
Power cable plug must be within easy reach
after installation (do not route it above the
hob).