27/EN
3. Move the front door to half-way.
4. Remove the front door by pulling it upwards to
release it from the right and left hinges.
Steps carried out during removing process
should be performed in reverse order to install
the door. Do not forget to close
hinge housing when reinstalling the door.
Replacing the oven lamp
Before replacing the oven lamp, make sure
that the product is disconnected from mains
and cooled down in order to avoid the risk of
an electrical shock.
Hot surfaces may cause burns!
The oven lamp is a special electric light bulb
that can resist up to 300 °C. See Technical
specifications, page 12
can be obtained from Authorised Service
Agents or technician with licence.
Position of lamp might vary from the figure.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to remove
it.
3. Remove the oven lamp by turning it counter
clockwise and replace it with the new one.
4. Install the glass cover.