EasyManuals Logo

CLEAN TOUCH Bidet CT-7000 Series User Manual

Default Icon
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
16
Product Installation
6. Attach the bidet seat to the catch plate
7. Connect the bidet hose to the bidet seat
Adjust the seat and front part of the toilet back and
forth so that they can correspond before fastening
the bolts.
Set the bidet seat at on the toilet bowl and push it
in until it clicks into place and is secure. Failure to
do may cause the seat to come apart.
Rotate the water inlet backward and hand-tighten
to secure. Make sure the hose is not twisted,
excessively bend it, or strip the plastic threads when
screwing the hose onto the bidet seat.
After connection, rotate the inlet back to the normal
position.
Connect the other end of the hose to the T-valve.
Check and ensure the rubber washer is not twisted
when fastening.
※ Caution for pairing
Be sure to proceed in the order of pairing method. If the order is reversed during
pairing, remove the remote control batteries and product power cord, wait tens of
seconds, and start again from the beginning.
To automatically pair the remote to the seat, install the batteries into the remote within
5 minutes of plugging the seat into the power outlet.
This product is an RF-type remote control with its own unique number assigned to each
product. There is little chance of confusion if two or more remote control bidet seats are
installed at the same place. In this case, contact the local dealer where you purchase
your seat for more assistance.
17
CR2032
CR2032
비데
설치방법
1. Find a place visible and reachable from
the toilet and clean the space thoroughly
before attaching the bracket.
2. Peel the adhesive protection film and
attach the bracket on the wall.
3. Insert the batteries deeply inside rst
and press the outside all the way down
to complete the insertion. Be sure to
fasten the bolt for children’s safety.
4. Gently insert the remote control into the
bracket.
5. If the automatic pairing is failed, follow
the below instructions.
Plug in the bidet seat.
The nozzle comes forward and goes backward,
then melody plays.
Insert the batteries.
Press any buttons to complete the pairing.
Melody is played to identify pairing completion.
6. Replace all batteries at the same time.
Do not mix old and new batteries.
Remote Installation
※ Bidet Filter Installation
Customers with hard water, well water, and rust
water can extend the life of their bidet seat by
installing an inline water lter.
Install the lter between T-valve and bidet hose.
The bidet lter should be replaced every 4~6months.
Failure to replace the filter on time may result in
water contamination, supply congestion, or filter
breakage.
Keep the battery out of reach of infants and toddlers and watch out them not to swallow
it. If a battery is swallowed, immediately consult a doctor.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CLEAN TOUCH Bidet CT-7000 Series and is the answer not in the manual?

CLEAN TOUCH Bidet CT-7000 Series Specifications

General IconGeneral
BrandCLEAN TOUCH Bidet
ModelCT-7000 Series
CategoryBathroom Fixtures
LanguageEnglish