17 EN
Use
PLEASE NOTE!
■ Only connect the device to a plug socket that is properly installed. The plug socket
must also be readily accessible after connection so that the connection to the mains
can quickly be isolated. The mains voltage must match the rating plate of the device.
■ Do not connect the device along with other consumers (with a high wattage) to a mul-
tiple socket in order to prevent overloading and a possible short circuit (fi re).
■ Do not use any extension cables more than 3 m long or cable extension reels.
■ Always switch off the device fi rst before the plug is pulled out of the plug socket. One
exception is when the device has fallen into water or in the event of a fault.
■ Always place the device with clear space above it and on all sides on a dry, fl at, solid
and heat-resistant surface.
■ It is essential that you follow the care labels for the textiles to be dried!
1. Set the height you want. To do this, open the clip (9), pull
out the telescopic rod (2) and then close the clip (9) again.
2. If you have not already done so, pull on the nylon balloon
(see the chapter “Assembly”).
The nylon balloon should sit immediately below the
mounting fl ange (8) so that it can fully infl ate.
00384_DE-EN-FR-NL_A5_V6.indb 1700384_DE-EN-FR-NL_A5_V6.indb 17 07.12.2020 08:27:4507.12.2020 08:27:45
To Next Page
Loading...
