17 EN
Cleaning and Storage
CAUTION!
■ Pull the mains plug out of the plug socket and allow the device to cool down com-
pletely before doing any cleaning!
■ Never immerse the device, the mains cable or the mains plug in water or other liquids!
■ Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
• Clean the device and the nylon balloon if necessary with a slightly damp cloth and a
little mild detergent if required. Then wipe down fully with a dry cloth.
• Allow all parts to dry completely before you put them away.
• Store the device in a clean, dry place that is protected from sunlight and is not acces-
sible to children and animals.
Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself.
Do not attempt to repair a defective
electrical device yourself!
Problem Possible cause / solution
The device does not
work. The LEDs do
not light up.
• Is the mains plug inserted in the plug socket correctly? Cor-
rect the fi t of the mains plug.
• Is the plug socket defective? Try another plug socket.
• Check the fuse of the mains connection.
• Is the device switched on? Set the timer (6) to a time.
Unusual noises
• Are the ventilation slots (5) covered up or blocked? Free up
the ventilation slots (5).
The device switches
off suddenly.
• Are the ventilation slots (5) covered up or blocked? Free up
the ventilation slots (5).
• The device has an automatic safety switch-off function. It
switches off automatically if it overheats. Allow the device
to cool down and switch it on again.
• Has the device fallen over? The device has a protective
switch that is activated if the device falls over. Set the de-
vice up again and switch it back on.
• Has the set time elapsed? Set the timer (6) to the time you
want again.
Odour produced
• You might notice a slight odour caused by production res-
idues the fi rst time you use the device. However, this is
harmless and will cease as you use the device.