Getting Started Guide
MAX EX SETUP
To Connect Max EX
1. Connect the Cat. 5 cable from the Link Out jack on the base unit to the Link In jack on the
conferencing pod.
2. Connect the base unit to the telephone jack using the RJ-11 telephone cable.
3. Connect the power cord to the base unit and plug it into an electrical outlet.*
* The power cord is not included with base units that plug directly into an electrical outlet.
To Connect Additional Units
1. Connect the 12' Cat. 5 cable to the Link Out jack on the first phone and the Link In jack on
the second phone.
2. Continue linking up to three additional Max EX phones in the same fashion. A total of four
units may be connected.
MAX™ EX QUICK START GUIDE
CLEARONE DOCUMENT 800-158-016-00
(REVISION 1.0) September 2007.
ClearOne Communications, Inc. 5225 Wiley Post Way, Suite 500, SLC, UT 84119 • 1-800-283-5936 • U.S. Patent No. D499,392 • Other
Patents Pending • © 2007 ClearOne Communications, Inc. All rights reserved. Information in this document is subject to change without notice.
TECHNICAL SUPPORT
Telephone: 1-800-283-5936 (United States)
1-801-974-3760
Fax: 1-801-977-0087
E-mail:
tech.support@clearone.com
CAUTION: Read the Safety Information in the user manual.
ACCESSING PROGRAMMING MENUS
Press and hold until appears on the LCD screen. Then press the key that
corresponds with the desired menu option and follow the instructions below.
To Next Page
Need help?
General
