ClearOne MAX EX Getting Started Guide

To Connect Max EX
1. Connect the Cat. 5 cable from the Link Out jack on the base unit to the Link In
jack on the conferencing pod.
2. Connect the base unit to the telephone jack using the RJ-11 telephone cable.
3. Connect the power cord to the base unit and plug it into an electrical outlet.*
* The power cord is not included with base units that plug directly into an electrical outlet.
To Connect Additional Units
1. Connect the 12' Cat. 5 cable to the Link Out jack on the first phone and the
Link In jack on the second phone.
2. Continue linking up to three additional Max EX phones in the same fashion. A
total of four units may be connected.
CONFERENCE PHONE SETUP
© 2004 ClearOne Communications, Inc. All rights reserved. Information in this document subject to change without notice.
800-158-016 Rev. 2.0. U.S. Patent No. D499,392.
ClearOne Communications ~ 1825 Research Way, Salt Lake City, UT 84119 ~ 1-800-945-7730 ~ www.clearone.com
Getting Started Guide
tel 1-800-283-5936
1-801-974-3760
fax 1-801-977-0087
e-mail tech.support@clearone.com
To Access the Programming Menus
Press and hold until appears on the LCD screen. Then press the key that
corresponds with the desired menu option and follow the instructions below.
PROGRAMMING OPTIONS
Max
™
EX
Audio Conferencing
TECHNICAL SUPPORT
*Press & hold the "1" key to enter a hyphen or the "*" key to enter a space in the number. If a number has already been
programmed, use CLEAR to delete the old number before entering the new number.
Ringer Melody
1
Dialing Mode
2
Flash Duration
3
Local Number*
4
Conference*
5
Service*
6
Key ProgrammingMenu Option
1-5 to select a new melody. Press to save selection.
Press . The current melody selection flashes. Press
1 for tone, 2 for pulse. Press to save selection.
Press . The current dialing selection flashes. Press
Press . Enter the phone number that you want the
Conference key to dial. Press to save the number.
duration. 1 = 600ms, 2 = 300ms, 3 = 150ms, 4 = 100ms, 5 = 80ms.
Press . The current duration flashes. Press 1-5 to select
Press to save selection.
appear on the LCD screen when the phone is in standby.
Press . Enter the phone number that you want to
Press to save selection.
Press . Enter the phone number that you want the
0 key to dial. Press to save the number.
Country
7
Press . Press the number key that corresponds with the
desired country. 1 = US/Canada/China/Japan/Mexico/Singapore,
2 = Europe CTR 21, 3 = Australia, 4 = S. Africa, 5 = Brazil, 6 = New Zealand,
7 = South Korea. Press to save the country setting.
Press CLEAR to exit Programming mode.
!
CAUTION: Read the Safety Information in the user manual.
25' Cat. 5 cable
RJ-11
telephone
cable
To Link In
To Link Out
Rear of conferencing pod
Rear of base unit
12' Cat. 5 cable
From Link Out
To Link In
To Link In
To Link Out on Base Unit
25' Cat. 5 cable

ClearOne MAX EX Specifications

General

Type	Conference Phone
Acoustic Echo Cancellation	Yes
Speakerphone	Yes
Noise Reduction	Yes
Microphone Range	20 ft
Power Supply	AC Adapter
Expansion Microphones	Yes
Coverage Area	20 ft diameter
Connectivity	Analog, USB