12
DANTE:
Dante Output option for ClearOne WS800 wireless receivers:
The Dante option for WS800 series wireless microphone receivers adds networked digital audio output to the receiver audio
output options. Each receiver slot is assigned an output channel on the installed Dante output card. These digital audio
streams can then be routed to any Dante input devices using the Dante Controller software application, shown below.
The Dante card comes pre installed in the WS800 receiver. There are 2 RJ-45 jacks on the rear panel of the
WS800 receiver used to connect the Dante card to the network. They are labelled ‘Primary’ and ‘Secondary’.
The Primary is used for the main network connection, and the Secondary can be used as a redundant backup
connection.
The Dante card is configured with each receiver slot assigned to a single Dante output channel. Slot 1 is
assigned to output 1; slot 2 is assigned to output 2, etc. The Dante connection is always active, so simply
connect the Ethernet cable to the Primary RJ-45 jack and use Dante Controller to route the signal.
To Next Page
Loading...