Installation of your ClearSounds
®
CSC600 Amplified Phone is easy.
There are some basic steps you need to take when you set-up your
CSC600 Phone for the first time.
1 Check parts list.
a Handset with handset cord and phone base
b Telephone line cord
c User’s Manual
d AC Power Adapter
2 Install (4) AAA Alkaline batteries (optional). This provides back-up power to
the Caller ID Screen.
3 Phone mounting installations.
4 Set the dialing mode.
5 Choose desktop or wall mount.
6 Set ringer and auxiliary alert.
7 Program your memory dial buttons.
INSTALLING THE OPTIONAL BATTERIES
The batteries are necessary in case of network power failure to save
stored numbers in memory and in the phone book.
1 Begin by unplugging the AC adapter & line cord before installing new
batteries.
2 Open the battery compartment door located on the bottom of your phone
by unscrewing the battery compartment door and removing it from the
bottom of your phone (screwdriver provided).
3 Correctly insert 4 AAA alkaline batteries (purchased separately) in the
battery compartment. Be sure to observe battery polarity as imprinted
on the base of the compartment.
4 Replace the battery compartment door and screw back in place.
BATTERY SAFETY
1 When replacing the batteries in your CSC600 phone, make sure to put
the batteries in correctly.
2 Never mix battery types (different chemistries, brands and/or fresh vs. used).
3 Never dispose of batteries in fire, as they could explode.
4 Remove worn-out batteries from equipment immediately and dispose of
promptly.
5 Do not attempt to recharge a battery unless the battery specifically is
marked “rechargeable.”
To Next Page
Loading...
