2
Step 1
Prepare car seat for Rear-Facing Installation:
• Rotate Recline Foot to Rear-Facing
position by pulling on edge of Recline
Foot and rotating it towards the front of
the seat until it locks in to position, as
shown in Figure 1.
• Remove Seat Cushion and install Anti-
Rebound Bar. See “Installing/Removing
Anti-Rebound Bar” in your car
seat manual.
Step 2
Select a forward-facing vehicle seating
location which has an inflatable vehicle
belt which can be used with this car seat.
Figure 1
lowered recline foot
Raised recline foot
To Next Page
Loading...
