5
Figure 7
Step 7
Switch the the lap portion of the lap/shoulder
belt to the automatic locking mode by pulling
the lap portion of the lap/shoulder belt all the
way out by holding the webbing and pulling
upwards, as shown in your vehicle manual.
Step 8
Tighten vehicle belt to secure the car seat
• Press down in center of car seat to
depress the vehicle cushion and pull
down on the lap portion of inflatable
lap/shoulder belt to tighten as shown
in Figure 7.
NOTE: The lap portion of the inflatable lap/
shoulder belt MUST remain tight and not
lengthen when pressure is released from the
seat. If the lap portion of the inflatable lap/
shoulder belt does not remain tight, go back
to Step 7 and refer to your vehicle manual.
To Next Page
Loading...
