26
Figure 42
Figure 43
Figure 44
IMPORTANT: The lap portion of the
inflatable lap/shoulder belt MUST remain
tight and not lengthen when pressure is
released from the seat. If the lap portion
of the inflatable lap/shoulder belt does not
remain tight, go back to Step 6 and refer
to your vehicle manual.
Step 12
Attach Tether Hook to vehicle top tether
anchor as shown in Figure 42 or Figure 43
and pull firmly on free end of strap until Top
Tether is snug.
Refer to vehicle owner’s manual for
recommended Top Tether routing and
identification of top tether anchor point
Step 13
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 44. Vehicle
belt and Top Tether must stay tight and car
seat should not move more than 1 in. (2.5 cm)
in any direction.
• If vehicle belt does not stay tight or
car seat cannot be securely installed,
try a different vehicle seating location
or install using LATCH. See “Installing
Forward-Facing Car Seat With LATCH”
on page 8 of this manual.
To Next Page
Loading...
