5
NOTE: The lap portion of the inflatable
lap/shoulder belt MUST remain tight and
not lengthen when pressure is released
from the seat. If the lap portion of the
inflatable lap/shoulder belt does not
remain tight, go back to Step 6 and refer
to your vehicle manual.
Step 9
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 7. Vehicle
belt MUST stay tight and car seat should
not move more than 1 in. (2.5 cm) in any
direction.
• If vehicle belt still does not stay tight or
car seat cannot be securely installed,
try a different vehicle seat location or
install using LATCH, see “Installing Rear-
Facing Car Seat With LATCH” in your
car seat manual.
Figure 7
To Next Page
Loading...
