16
9.3 Leather cape
The cape can be brushed or cleaned with a damp sponge. (Do not wash, dry clean, iron or use chlorine
bleach.)
9.4 Inner collar
For reasons of hygiene, the inner collar should be washed daily to remove sweat and dust.
Detach the collar from the cape (zipper) and wash in warm water and a mild detergent. The collar can be
dried in a tumble dryer at the lowest temperature setting. Do not dry clean.
9.5 Sweatband/helmet suspension
The sweatband, helmet suspension, suspension strap and chin strap can be washed in warm water and a
mild detergent. See 7.2 for how to detach the components.
9.6 Blast helmet
The helmet should be cleaned with a disinfectant. A suitable product is Indicur from Henkel*.
9.7 Inner lens
The inner lens should be replaced if it becomes soiled or scratched. It can be cleaned with warm water
and a mild detergent. Solvents such as alcohol, white spirit or ammonia must not be used. Allow the lens
to air-dry. The use of cloths or similar may scratch the lens.
10 Storage
10.1 Daily storage
During breaks or at the end of work, the helmet should be hung by the handle in a clean place.
Attention! This product has only been tested for its compatibility with our helmet. Please follow the
manufacturer’s instructions for use. We assume no liability for any skin reactions or other health problems
associated with the use of the disinfectant.
10.2 Long-term storage
After cleaning and drying the helmet, tuck the cape inside. Pack the helmet in a sealed bag or film to
protect it from dirt and moisture.
To Next Page
Loading...
Need help?
General