Cleral KILOAD User Manual

CALIBRATION MANUAL
SUPPORT – QUESTIONS
CONTACT
1-866-485-4037
KILOAD BASICS
The Kiload weighs by measuring the “flex” of the front axle
(A) and the air pressure in the air bags/rear axles (B).
Because of this, it is important with this scale as with all
scales that the suspension must be as “Neutral” as possible
when you acquire your weight readings. This simply means
that a level load area and a „relaxed‟ suspension is the best
way to acquire weights.
To begin the days work and just prior to loading your first
load, the scale should be “ZEROED”.
To Zero: preferably where you will be loading, stop the truck
and „relax‟ the suspension. Now push the “Zero” button-the
display will ask you “Zero-yes?” now push the “Zero” button
one more time and the scale will automatically zero. If the
scale reads “Zero-no?, push the up or down arrow to change
it to read “Zero-yes? Then push the “Zero” button, now you
are ready to load. The scale should be Zero‟ed periodically
throughout the day to compensate for temperature changes
and load area changes. You are now ready to load.
Once the truck is loaded, take a look at the “T” total weight
reading on your scale. It will show the weights on the “A” front
axle and “B” rear axle group separately.
To adjust the weight, first push the “DOWN” arrow on the
KILOAD, then lower your tag axle as necessary to obtain the
proper balance between the “A” front axle and “B” rear
axle(s).
When you are finished with the load and before you take on
another load, PUSH the UP arrow to return to normal
weighing.

Cleral KILOAD Specifications

General

Brand	Cleral
Model	KILOAD
Category	Measuring Instruments
Language	English

Summary

Calibration Manual Overview

Kiload Basics Explained

Explains the Kiload system, its weighing mechanism, and the importance of neutral suspension for accurate readings.

Empty Calibration Procedure

Initiate Empty Calibration Entry

Press CAL key to begin entering 'Empty' weights, initiating the calibration process.

Set Steering Axle (A) Empty Weight

Adjust and enter the 'Empty' weight for the steering axle (A) using the Up/Down arrow keys.

Set Rear Axle (B) Empty Weight

Adjust and enter the 'Empty' weight for the rear axle group (B) using the Up/Down arrow keys.

Finalize Empty Calibration Entry

Press the CAL key to confirm and complete the entry of 'Empty' weights for the calibration.

Full Calibration Procedure

Initiate Full Calibration Entry

Press CAL key to switch to 'Full' calibration mode and begin weight entry.

Set Steering Axle (A) Full Weight

Adjust and enter the 'Full' weight for the steering axle (A) using the Up/Down arrow keys.

Set Rear Axle (B) Full Weight

Adjust and enter the 'Full' weight for the rear axle group (B) using the Up/Down arrow keys.

Finalize Full Calibration Entry

Press the CAL key to confirm and complete the entry of 'Full' weights for the calibration.

Limited Warranty Information