EasyManua.ls Logo

Cleveland KEL-40 - User Manual

Cleveland KEL-40
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1333 East 179th St.
Cleveland, Ohio
U.S.A. 44110
Phone: (216) 481-4900 Fax: (216) 481-3782
Visit our web site at www.clevelandrange.com
SE95036 Rev. 2
Operators Manual
Installation, Operation & Service
Electric Floor Model Kettles
For units built after August 1999
MODELS:
KEL-25, KEL-30, KEL-40, KEL-40-SH, KEL-60, KEL-80, KEL-100
KEL-25-T, KEL-40-T, KEL-60-T, KEL-80-T, KEL-100-T
KEL-40-SH, KEL-40-TSH, KEL-60-SH, KEL-60-TSH
Question and Answer IconNeed help?

Do you have a question about the Cleveland KEL-40 and is the answer not in the manual?

Summary

GENERAL

INSTALLATION

Refer to specification sheets for clearance and drain requirements, then unpack the kettle.

CLEARANCE REQUIREMENTS AND DRAIN LOCATIONS

Clearance Requirements

Specifies minimum recommended clearances for service around the kettle.

FLOOR DRAIN DETAIL AND ASSEMBLY

WIRE CONNECTION AND WATER

Wire Connection

Guidance on electrical connection, grounding, and matching supply to kettle requirements.

INSTALLATION CHECKS

OPERATING INSTRUCTIONS

OPERATING THE KETTLE

CARE AND CLEANING

HINGE ASSEMBLY PARTS

KETTLE BOTTOM & SIDE DIAGRAM

KETTLE BOTTOM & SIDE PARTS LIST

CONTROL CONSOLE COMPONENTS - HAND TILT DIAGRAM

CONTROL CONSOLE COMPONENTS - HAND TILT PARTS LIST

CONTROL CONSOLE COMPONENTS - POWER TILT DIAGRAM

CONTROL CONSOLE COMPONENTS - POWER TILT PARTS LIST

2 TANGENT DRAW-OFF VALVE PARTS

MAINTENANCE

Inspection and Maintenance Checklist

Guideline for semi-annual checks on gaskets, covers, hand wheel, tilting, pressure gauge, relief valve, and temperature.

CALIBRATING PROCEDURE

PRESSURE RELIEF VALVE TESTING PROCEDURE

RESERVOIR FILL PROCEDURES

KETTLE VENTING INSTRUCTIONS

VACUUM LEAK TEST PROCEDURE

REPAIRING STEAM JACKETED FITTING LEAKS

DIAGNOSTIC GUIDE

Kettle Not Heating Troubleshooting

Troubleshooting steps for a kettle that is not heating, covering causes and fault isolation.

DIAGNOSTIC GUIDE - SLOW HEATING

DIAGNOSTIC GUIDE - OVERHEATING

DIAGNOSTIC GUIDE - RED LED ILLUMINATED

WIRING DIAGRAM (200-240 v)

WIRING DIAGRAM (380-600 v)

Cleveland KEL-40 Specifications

General IconGeneral
BrandCleveland
ModelKEL-40
CategoryKettle
LanguageEnglish

Related product manuals