Disassembly
Removing and Installing the Video Card 2 - 23
2.Disassembly
Installing a New Video Card
1. Prepare to fit the video card into the slot by holding it at about a 30° angle (Figure 18e).
2. The card needs to be fully into the slot, and the video card and socket have a guide-key and pin which align to
allow the card to fit securely (Figure 18f)
.
3. Fit the connectors firmly into the socket, straight and evenly.
4. DO NOT attempt to push one end of the card in ahead of the other.
5. The card’s pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket
as it will go. DO NOT FORCE the card; it should fit without much pressure.
6. Secure the card with screws & (Figure 17 on page 2 - 22).
7.
Place the heat sink back on the card, and secure the screws in the order indicated in Figure 17 on page 2 - 22.
8.
Reinsert the component bay cover, and secure with the screws as indicated in Figure 9 on page 2 - 13.
To Next Page
Loading...
Need help?
General
