Click 0605594 - Page 10

10
Display Operating mode
Strong air speed moder
The appliance switches to the highest level of ventilation mode.
Sleep Mode
Reduce the current gear by 1 gear every 15 minutes, and the minimum is reduced to
the first gear.
Natural air speed mode
Air volume 3-5-7 gear air-speed in turn.
ECO mode
Only active in heating mode.
- If the room temperature is below 18 °C, the appliance operates at high speed
- if the room temperature is between 18-22 °C, the appliance operates at low speed
- if the room temperature is above 22 °C, the appliance operates at the lowest fan
speed
Note: ECO mode can only be selected in heating mode. If you change the speed during
an active operating mode, the operating mode is deactivated and must be reactivated.
Oscillation button
Press the Shake head button to enable or disable the shake head.
The default shake head Angle is 80±5 degrees.
Ventilation level button
To switch to fan mode, press the button.
Press the + button repeatedly to increase the desired ventilation level.
Press the - button repeatedly to reduce the desired ventilation level.
You can choose between 9 dierent ventilation levels.
The desired ventilation level is adopted directly.
Heating level button
Press the button to switch to heating mode.
Press the button + or - repeatedly to set the desired ventilation level.
You can choose between 4 dierent ventilation levels.
Note: The heating is only activated if the set temperature is above the current room temperature.
Temperature button
Press the button to set the desired temperature. 25°C is the preset temperature.
You can set the temperature from 5°C - 35°C.
The desired temperature setting is adopted directly.
Note: The heating is only activated if the set temperature is above the current room temperature.As soon as
the room temperature falls below the set temperature, the appliance switches on automatically until the set
temperature is reached again. In this way, the room temperature remains constant and power consumption
is kept as low as possible.
Note: The default setting for the heating is 25 °C.
If the room temperature falls below 0 °C, the LED display only shows - - as these cannot be displayed.
ECO mode.
Only active in heating mode.
- If the room temperature is below 18 °C, the appliance operates at high speed.
- if the room temperature is between 18-22 °C, the appliance operates at low speed.
- if the room temperature is above 22 °C, the appliance operates at the lowest fan speed.
Note: ECO mode can only be selected in heating mode. If you change the speed during
an active operating mode, the operating mode is deactivated and must be reactivated.
The appliance switches o automatically if it has been in continuous operation for 12 hours.
Note: The heater initially emits heat from the lefthand air outlet and after about 20 seconds
emits heat from the right-hand side. This is a normal process.
After the appliance has been switched o from heating mode, it automatically switches to blower mode and
blows out a stream of air for approx 30 seconds to allow the heating element to cool down.The 30 second
countdown timer is displayed on the LED screen.